[ig_z 0]

На сеггере увидел упоминание о сабже. В SWD скорость в 10 раз выше. Кто нибудь работает с таким?

[АДИКМ 0]

не в SWD. А в SWV . Это разные вещи. swv пока софтом не поддерживается.

[ig_z 0]

Или хотя бы словесное описание различий в схемах электрических принципиальных от JLink v5.

[bigarmer 0]

9.6.1.4 Version 5.2

Identical to version 5.0 with the following exception:

Target Interface

nTRST is push-pull type

RESET is open drain

9.6.1.5 Version 5.3

Identical to version 5.2 with the following exception:

5V target supply current limited

5V target supply (pin 19) of Kick-Start versions of J-Link is current monitored

and limited. J-Link automatically switches off 5V supply in case of over-current to

protect both J-Link and host computer. Peak current (<= 10 ms) limit is 1A,

operating current limit is 300mA.

9.6.1.6 Version 5.4

Identical to version 5.3 with the following exception:

JTAG interface is 5V tolerant.

9.6.1.7 Version 6.0

Identical to version 5.4 with the following exception:

Outputs can be tristated (Effectively disabling the JTAG interface)

J-Link supports SWV (Speed limited to 500 kHz)

9.6.1.8 Version 7.0

Uses additional pin to the UART unit of the target hardware for SWV support

(Speed limited to 6 MHz).

[bigarmer 0]

Version 6.0

Identical to version 5.4 with the following exception:

Outputs can be tristated (Effectively disabling the JTAG interface)

J-Link supports SWV (Speed limited to 500 kHz)

Version 7.0

Uses additional pin to the UART unit of the target hardware for SWV support

(Speed limited to 6 MHz).