На SPI тишина, активность только на флеш и шине озу короткое время после сброса.
Но процесс загрузки, как я понимаю, еще не начинается, а происходит Remap.
Светодиоды красный и зеленый постоянно светятся.
Вот выдержка из документации на проц.
4.1.2.2 Boot Algorithm
The steps in the software boot process are:
1. Remap memory
2. Turn the green LED off and the red LED on
3. Disable the Watchdog timer
4. Read the Boot State
5. Set up the Clocks to run from external clocks (PLLs are not configured)
6. Based on the Boot State memory width, follow steps A, B, and C.
A. Initialize the SYNC Flash and SMC memory interfaces for slow (maximum
compatibility) operation
B. Initialize the SDRAM interfaces.
C. Perform minimal memory tests
7. Based on the contents of the SysCfg register, start serial download (see Figure 4-1), and
then follow Steps A, B, C, D, E, and F.
A. Initialize UART1 to 9600 baud, 8 bits, no parity, 1 stop bit
B. Output a ”<” character
C. Read 2048 (decimal count) characters from UART1 and store these in the internal
Boot buffer (alias for the Ethernet Mac buffer)
D. Output a ”>” to signify 2048 characters have been read
E. Turn on Green LED
F. Jump to the start of the internal Boot Buffer
