Приветствую ВСЕХ!
Может кто сталкивался с такого рода ошибками на этапе трансляции в новой версии ISE 12.2
ERROR:NgdBuild:76 - File
"D:\AutOF\FPGA_design\ISE\autof_v1/ddr_sdram_wrapper.ngc" cannot be merged
into block "U2/DDR_SDRAM" (TYPE="ddr_sdram_wrapper") because one or more pins
on the block, including pin "MPMC_MCB_DRP_Clk", were not found in the file.
Please make sure that all pins on the instantiated component match pins in
the lower-level design block (irrespective of case). If there are bussed
pins on this block, make sure that the upper-level and lower-level netlists
use the same bus-naming convention.
ERROR:NgdBuild:76 - File
"D:\AutOF\FPGA_design\ISE\autof_v1/microblaze_0_wrapper.ngc" cannot be merged
into block "U2/microblaze_0" (TYPE="microblaze_0_wrapper") because one or
more pins on the block, including pin "Trace_DCache_Read", were not found in
the file. Please make sure that all pins on the instantiated component match
pins in the lower-level design block (irrespective of case). If there are
bussed pins on this block, make sure that the upper-level and lower-level
netlists use the same bus-naming convention.
Проект под ISE типа HDL, один из sub-модулей - проект EDK, в котором Microblaze, MPMC и ещё с десяток других модулей.
Проект успешно работал под 11.5. Переход на новую версию - требование клиента.
Уже пробовал собирать весь проект EDK заново на новой версии, т.к. бывают косяки во время миграции со старой версии на новую. Однако это не помогло.
Проект в EDK проходит генерацию нетлиста без ошибок.
Заранее благодарен за помошь!