Debug channel initialized

Hit key to enter loader

Load U-BOOT from dataflash[c0008000] to SDRAM[20f00000]

Set PLLA and start U-BOOT˙

U-Boot 1.1.1 (May  4 2006 - 11:47:26)

U-Boot code: 20F00000 -> 20F1BC3C  BSS: -> 20F20554
RAM Configuration:
Bank #0: 20000000 32 MB
Unknown flash manufacturer 0x00900090
Flash:  0 kB
DataFlash:AT45DB642
Nb pages:   8192
Page Size:   1056
Size= 8650752 bytes
Logical address: 0xC0000000
Area 0:	C0000000 to C0007FFF (RO)
Area 1:	C0008000 to C001FFFF (RO)
Area 2:	C0020000 to C0027FFF 
Area 3:	C0028000 to C083FFFF 
In:    serial
Out:   serial
Err:   serial
eth: setting MAC address to 12:34:56:78:9a:bc
PHY not connected!!

Link: 100baseTX Full Duplex
Hit any key to stop autoboot:  3  2  1  0 
## Booting image at 20a00000 ...
   Image Name:   
   Image Type:   ARM Linux Kernel Image (gzip compressed)
   Data Size:    1296669 Bytes =  1.2 MB
   Load Address: 20008000
   Entry Point:  20008000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK

Starting kernel ...

Linux version 2.6.21.5 (root@slava2005) (gcc version 3.4.6) #11 PREEMPT Tue Jul 10 13:26:24 MSD 2007
CPU: ARM920T [41129200] revision 0 (ARMv4T), cr=c0003177
Machine: Rainbow 1.1s
Memory policy: ECC disabled, Data cache writeback
Clocks: CPU 179 MHz, master 44 MHz, main 18.432 MHz
CPU0: D VIVT write-back cache
CPU0: I cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets
CPU0: D cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets
Built 1 zonelists.  Total pages: 8128
Kernel command line: noinitrd root=/dev/mmcblk0p1 rw console=ttyS0,115200 mem=32M rootdelay=10
AT91: 96 gpio irqs in 3 banks
PID hash table entries: 128 (order: 7, 512 bytes)
Console: colour dummy device 80x30
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 32MB = 32MB total
Memory: 29720KB available (2428K code, 184K data, 104K init)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
NetWinder Floating Point Emulator V0.97 (double precision)
NTFS driver 2.1.28 [Flags: R/O].
io scheduler noop registered
io scheduler anticipatory registered (default)
atmel_usart.0: ttyS0 at MMIO 0xfefff200 (irq = 1) is a ATMEL_SERIAL
atmel_usart.1: ttyS1 at MMIO 0xfffc4000 (irq = 7) is a ATMEL_SERIAL
RAMDISK driver initialized: 1 RAM disks of 8192K size 1024 blocksize
eth0: Link now 100-FullDuplex
eth0: AT91 ethernet at 0xfefbc000 int=24 100-FullDuplex (12:34:56:78:9a:bc)
eth0: Micrel KS8721 PHY
at91_ohci at91_ohci: AT91 OHCI
at91_ohci at91_ohci: new USB bus registered, assigned bus number 1
at91_ohci at91_ohci: irq 23, io mem 0x00300000
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
udc: at91_udc version 3 May 2006
mice: PS/2 mouse device common for all mice
ds1307 0-0068: rtc core: registered ds1307 as rtc0
at91_i2c at91_i2c: AT91 i2c bus driver.
AT91 MMC: 4 wire bus mode not supported by this driver - using 1 wire
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
ds1307 0-0068: setting the system clock to 2000-01-01 00:32:19 (946686739)
Waiting 10sec before mounting root device...
mmc0: host does not support reading read-only switch.  Assuming write-enable.
mmcblk0: mmc0:b368 SDC   249856KiB 
 mmcblk0: p1 p2
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
VFS: Mounted root (ext2 filesystem).
Freeing init memory: 104K
Mount failed for selinuxfs on /selinux:  No such file or directory

INIT: version 2.86 booting

hostname: the specified hostname is invalid
Activating swap...done.